Alrighty then... quite simple... much cheaper then byin one... and ya can make it any legth ya want. (as long as its shorty than factory.
Tools n Supplies
1. an antenna that has the same diameter from top to bottem.(cant use the ones that have the "swirls" goin down)
2.something that will pop the lil ball off the end (i used a pry bar, vise, and small hammer)
3.something to cut yer antenna w/ (i used an airtool cause i'm lazy)
4.a file (used a grinding wheel cause again, i'm lazy)
5.spray paint... if ya want to paint it that is (i did despite being lazy)
__________________________________________________ ________
sismple procedure...
1. pop the ball off the end of the antenna... It should not be hard... the only thing holding it on is pressure... and beware... when it pops off it flies!
2. well now yer gonna cut the antenna to length... you can use a some heavy duty snips, or or an air or electric cutter...
3. file down the end a tit bit, just get all the barps off and maybe even give it a bit of a taper.
4. popped that son er bitch ball back on (if ya ever found it after it was removed, lol)
5. paint it if a want... after drying put it back on...
6. Say to yerself... "Yeh, I'm Awesome"
_____________________________________________
For those of you that have a hard time w/ mechanical ****... to remove the antenna ya have to TURN it... And remember, Righty tighty, lefty loosy...
____________________________________________
before
after
